Unique color
1)Covered with unique and special color paint, it gives you a visual surprise.
Nice looking
2)Fashionable appearance gives it a cool looking which is totally different from any others.
Mini Model
A mini model for perfect indoor flight, this artistic helicopter can be played in your living room, even your bedroom.

1.Fashionable design with unique colored paint
2.Tri-band switch allows 3 helicopters to fly together
3.Coaxial structure enables it to fly stably
4.Infrared control system
5.Perfect for indoor flying
6.Extended flight time of 10 minutes after charged by controller for about 35-45 minutes
7.3-channel control enables the chopper to fly up, down, left, right, forward and backward

Preparing for take OFF:
1) Switch the controller ‘ON’, LED light on controller will begin to flash.
2）CAUTION: Please make sure the left joystick is in the lowest position before turning on the controller.
3）Move the left joystick on the controller fully forward and fully backward,this action will lead the controller to connect with the helicopter. Then LED will light up RED completely.
4）Tri-band switch(A,B,C)allow 3 players to play together. A different frequency for each player. Ensure helicopter is turned ‘OFF’ before changing frequency.
5）Switch the helicopter 'ON'(Switch on side of the fuselage)

Launch time: Take Off and Landing
1)Move the left joystick slowly forward–the rotors will start to spin
2)As you move the joystick past the halfway point the helicopter will liftoff
3)To ascend- move the left stick further forward (Very small adjustment is needed as controls are sensitive)
4)To descend- slowly move the stick backward

Steering:
1)To turn the nose of the helicopter left, move the right hand joystick to the left
2)To turn the nose of the helicopter right, move the right hand joystick to the right
3)To fly the helicopter forward, move the right hand joystick forward. The joysticks are very sensitive, small controlled movements should be used at all the time.
4)To fly the helicopter backward, move the right hand joystick backward.

Charging Salvation 30
1.Switch off the helicopter and the remote controller.
2.Slide out the charging wire cover on the back of controller.
3.Connect the charging wire to the charging jack at the bottom of the helicopter carefully.Do not force.
4.Switch the controller to be "ON".
5.The charging indicator light on the controller will light up to GREEN.
6.The helicopter is fully recharged once the charging indicator light off.
7.Leave the battery cooled down for 5 minutes,then you are ready to fly.

Note:Be sure that the battery inside the helicopter has been cooled down for 10-15 minutes after flying before recharging.