Flying your Salvation 32 (Basic knowledge)
1. Switching on your Salvation 32
Be sure that the left lever is to the bottom before you switching on the power switch on the Controller.
Switch on the power switch on the controller firstly, then switch on the helicopter.
Switch on the power switch on the controller, and the indicator light will light up to RED.
Switch on the helicopter, the ON/.OFF switch is located at the bottom of the helicopter.
Put the helicopter on the ground with tail posing away from yourself and try to keep the helicopter flying 1-2 meters away from yourself as well.
2. Taking off your Salvation 32
Put the helicopter on the smooth place, and it may fail to fly if the place is not smooth enough.
Push the left lever upwards slowly.
Do not stare at the controller, keep your eyes on the helicopter will be much better.
After taking off, push down the left lever a little to keep the helicopter flying at the certain height.
Push the left lever upwards a little once the helicopter starts dropping down.
Push the left lever slowly when the helicopter starts flying up too much.
Move the right lever if you need to change the flying direction.
3. Steering your Salvation 32
Flying up and down
Move the left lever upwards slowly, the helicopter will fly higher and higher. If you want to fly lower, just slightly move the left lever downwards. In order to make the helicopter flying stable, do not move the left lever too much, but a little bit every time.
Turning left and right
Fly your helicopter stably in the air with tail posing away from you, move the right lever to right if you want the helicopter to turn to the right (and vice versa).
Forwards and backwards
Fly the helicopter stably in the air with tail posing away from you, move the right lever forwards if you want the helicopter to go forwards (and vice versa).
Note: Beginners will be easy to overmove the levers, but not move the levers a little bit correctly.
Setting band on Salvation 32
It allows 3 Salvation 32 to fly together at the same time by setting 3 different bands on the controller.
1. Switch on the power switch on the controller firstly, and then switch the band to your ideal band (Band A, B, C).
2. Switch the ON/OFF which is located ion the bottom of the helicopter.
Be sure that the band (A, B, C) you set for each helicopter should be different from the others when you choose two or three helicopters to fly together